Equipment maintenance is critical to increasing productivity. Regular maintenance can ensure the normal operation of the equipment and reduce the possibility of failure. The Spring Festival holiday is approaching. Syutech Machinery reminds you to do a good job in equipment maintenance before the holiday to ensure that the equipment is running well in the coming year, so that you can celebrate the New Year with peace of mind!
certainly! Here is the translation: Use an air gun to blow off debris and oil from the machine.
Use a vacuum cleaner to remove dust from the inside of the electrical box.
Grease all external grease fittings. Apply lubricating grease to the parts of the machine's moving mechanism that need lubrication.
Spray anti-rust oil on the iron parts of the machine that are prone to rust.
Drain the water from the air tank and add oil to the air source processor.
Check whether there is sufficient oil in the transmission motor.
Turn off the equipment and gas supply, and turn off the main power supply.
Computer Panel Saw
Remove the large and small saw blades and store them properly.
Use an air gun to clean the saw frame and mechanical arm, apply anti-rust oil on the wool felt, and move it back and forth to evenly lubricate the guide rails.
Use a clean cloth to apply anti-rust oil to the side chains and guide rails.
Use an air gun to remove any remaining dust from the press beam and apply oil to keep it lubricated.
Open the drain valve while the equipment is ventilated until the water is completely drained.
After the saw truck, mechanical arm, and side bracket return to the origin, turn off the power and cut off the power and air source.
When the power is off and the air is off, add 32# lubricating oil to the oil cup of the lubricator to the 2/3 mark.
Clean the fan filter and use a vacuum cleaner to remove debris from the surface of components in the electrical box.
CNC Nesting Cutting machine
Open the cutting machine spindle to the middle position to ensure uniform stress distribution on the frame.
Use an air gun to blow off the dust on the machine and apply engine oil to the moving rails and frame.
For manual tool changers, oil should be applied to the collet and grease should be applied to the spindle taper hole.
While the equipment is ventilated, drain the water from the air tank.
Clean the electrical control box and place desiccant to prevent moisture from affecting electrical components.
Clean dust and debris from the vacuum pump filter. Place a piece of material on the processing table to prevent the table pad from absorbing water and swelling.
Use pearl cotton and stretch film to pack the equipment to prevent dust accumulation.
CNC six Side drilling machine
Stop each axis at the mechanical zero position.
Remove dust from the inside and outside of the device and wipe it clean with a rag. Apply engine oil to the gears, racks, and guide rails, and add grease to the external oil nozzles.
Drain the water from the air tank while the equipment is ventilated.
Back up operating software to prevent data loss.
Turn off the main power of the equipment, clean the dust and debris in the electrical control box, and place desiccant to prevent moisture.
Wrap equipment in stretch wrap to prevent mice from chewing through wiring.
If you have any specific questions about this information, please feel free to ask!
We are specialized in producing all kinds woodworking machine,cnc six side drilling machine,computer panel saw,nesting cnc router,edge banding machine,table saw,drilling machine,etc.
Tel/whatsapp/wechat:+8615019677504/+8613929919431
Email:zywoodmachine@163.com/vanessa293199@139.com
Post time: Feb-01-2024